OpelScanner

English Section => Diagnostics => Topic started by: gooberface on May 06, 2015, 01:08:37

Title: Idle speed Y26SE
Post by: gooberface on May 06, 2015, 01:08:37

Hey there.

Does anyone here know, if you can adjust idle speed on these or are they "hardcoded" ? I can see the idle speed just fine in the CANv2 software, but I can´t see anywhere to adjust. I´ld think it has to be done in the ECU, since there is no ICV on these drive-by-wire engines.

As is, it is idling at around 725 when warm, but I know they can go as low as 450 due to a heavy weight flywheel. Since I drive a lot in the city, I stop by a lot of red lights and thought it could be an easy way to save a bit of fuel.

I must say, I like the software, but "intuitive" isn´t a word that springs to mind when using it :)

Title: Re: Idle speed Y26SE
Post by: Artur on May 06, 2015, 11:28:04

Let me check first.

Title: Re: Idle speed Y26SE
Post by: kadett90 on May 16, 2015, 11:39:00

I think you can't program idle speed in this ecu.
There is no such option.

Title: Re: Idle speed Y26SE
Post by: gooberface on July 08, 2015, 05:02:57

Quote from: Artur on May 06, 2015, 11:28:04

Let me check first.

Hello Artur

Did you have a chance to look at this ?

Title: Re: Idle speed Y26SE
Post by: Artur on July 13, 2015, 04:09:00

not yet, I'm on vacation now.

Title: Re: Idle speed Y26SE
Post by: gooberface on October 09, 2015, 01:55:27

Hey Artur.

How did your vacation go ? ;)

Title: Re: Idle speed Y26SE
Post by: Artur on October 09, 2015, 08:35:45

Not bad, thanks.

Title: Re: Idle speed Y26SE
Post by: gooberface on November 06, 2015, 03:37:34

Hey Artur.

Any update on this ? I know you are probably busy and it IS an old engine, but it would be nice, if it was possible :)