Hey there.
Does anyone here know, if you can adjust idle speed on these or are they "hardcoded" ? I can see the idle speed just fine in the CANv2 software, but I can´t see anywhere to adjust. I´ld think it has to be done in the ECU, since there is no ICV on these drive-by-wire engines.
As is, it is idling at around 725 when warm, but I know they can go as low as 450 due to a heavy weight flywheel. Since I drive a lot in the city, I stop by a lot of red lights and thought it could be an easy way to save a bit of fuel.
I must say, I like the software, but "intuitive" isn´t a word that springs to mind when using it
